How to find engine mounts for 66 cj5 with 225 v6?

I have had the hardest time locating engine mounts for my jeep. It has the 225 v6 Buick motor. Any help?

 

I recently ordered each of those parts from NAPA and I could not tell the difference between the two. They are actually better than stock because they incorporate a fail safe bracket. These parts are much less expensive than anything you'll fine on eBay or other aftermarket sources.
I've been told that they are the same as a 1975 Buick Apollo car.

 

are they not stamped "L" and "R"?

 

Well I went to the local NAPA and picked these parts up. The 602-1390 was correct, but the 602-1006 was completely wrong. The guy at the counter thinks that the wrong mount was put into that box, so he ordered another. We will see when it shows up tomorrow. BTW, my original mounts were marked as "right" and "left". The NAPA parts are not marked however.

 

Walcks has them... I have an extra set as well, used but in great shape.

 

I just ordered these Napa motor mounts. Pretty much identical side to side.

But, doing some measuring on my F135 that resides vs. my 225 waiting to go in, if I keep my crank centerline the same height, the through-bolt for the mount is the same height as the steering arm.

Probably going to return them this week and go with the Novak mount kit as it looks like it will clear the Ross steering.

Unless i'm measuring wrong?

 

602-1390 is the LEFT
602-1006 is the RIGHT
Here are pics of my old and new mounts side by side. The camera angle distorts these some. The mounts are very similar.

 

I picked up the other 602-1006 mount today from NAPA. Sure enough, it was the correct one this time.

 

Factory 225 mounts clear Ross steering just fine.

 

Are the frame mounts the same for the F134 and the :v6: 225? I assumed they were different?

 

Completely different.