Twin Stick and Overdrive Stick Location.

I need to cut a hole in my fiberglass body for my twin sticks on my D18 and I was wondering if anyone had a picture or measurements of the hole location in the floor compared to the pivot point on the front output. My jeep came in pieces and I now have the body in place and I am ready to start cutting to install the sticks. I suppose the 2 wheel drive position would be what I am looking for. Is it directly above, 1" offset front or back? etc.

Also, has anyone ever modified the pivot shaft in a way to utilize it for a Warn overdrive? I have a th350 and I am struggling to find a bolt down location for the bracket in it's present form.

Todd

 

I picked up a used overdrive that the prior owner had modified the twin sticks so that he could add a third stick for the o.d. He machined the bosses down an all three sticks and heated and bent the one for the overdrive. I think I still have the sticks and shift rod if you might be interested.

 

I mounted my OD bracket to the rear corner of my trans by cutting the bracket in half (longways), flipping it 180* and re welding. The OD stick now mounts behind the twin sticks . I did have to bend the OD stick al little as well.