1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Brake/Clutch shaft rebuild

Discussion in 'Early CJ5 and CJ6 Tech' started by jzeber, Nov 14, 2006.

  1. Nov 14, 2006
    jzeber

    jzeber Well-Known Member 2022 Sponsor

    Morgan Hill, Ca
    Joined:
    Nov 15, 2003
    Messages:
    3,326
    I did a search and looked in the tech section but could not find anything. The brake pedal on my 71' has a terrible wobble where it rides on the cross shaft. I guess this is pretty common. Does someone make a kit to replace the bushing or do I just need to find one that will fit?

    Thanks
     
    jzeber, Nov 14, 2006
    #1
  2. Nov 14, 2006
    sparky

    sparky Sandgroper Staff Member Founder

    Perth, WA
    Joined:
    Sep 20, 2002
    Messages:
    9,221
    sparky, Nov 14, 2006
    #2
  3. Nov 15, 2006
    Jeeper Preacher

    Jeeper Preacher My Little Grill Girls

    Wilmington, NC
    Joined:
    Feb 18, 2006
    Messages:
    109
    Sparky: The Vernco site is not up anymore...any other site sources that would communicate the same message. Thanks!
     
    Jeeper Preacher, Nov 15, 2006
    #3
  4. Nov 15, 2006
    panzer

    panzer Super Mod Staff Member

    Columbus, OH
    Joined:
    Dec 9, 2003
    Messages:
    1,245
    I think Old Bill had something on it. Maybe Thad will chime in.
    Maybe this will help.
     
    panzer, Nov 15, 2006
    #4
  5. Nov 15, 2006
    sparky

    sparky Sandgroper Staff Member Founder

    Perth, WA
    Joined:
    Sep 20, 2002
    Messages:
    9,221
    Dunno. I didn't think or worry about that too much with the other suggestions listed in that thread I figured there were two suggestions, that was enough. Two outa three ain't bad. ;)
     
    sparky, Nov 15, 2006
    #5
  6. Dec 17, 2006
    tgregg

    tgregg Member

    Oak Hills, CA...
    Joined:
    Apr 14, 2005
    Messages:
    529
    Wow! $2 whole dollars for the Jeep kit, I want one. Anyway thanks everybody I see how it all works now. I went out and pressure washed the assembly and my slack appears to be mostly in the bracket so I will order one and a shaft. When I get the steering conversion done the parts should be here. thanks everyone
     
    tgregg, Dec 17, 2006
    #6
New Posts