E-brake schematic?

Getting ready to install the driveshaft e-brake on my '55, just waiting for parts.(Imagine that). Anyway, does anyone know of a good assembly diagram/description? I have a Chilton manual but the picture is not good and the assembly procedure is unclear. A photo of a complete e-brake would be very helpful. I'm starting from scratch, it was off of the Jeep and incomplete when I started. Thanks

 

Herm has a hand brake diagram on his webpage. I havent found anything that describes how to assemble it. Its pretty basic after you have all the clean parts in at hand.
The shoes are held on with springs and a post arrangement that they fit under.
One post is part of the adjuster boss, the other is just a rivited post. If it is gone, there is not much you can do.
Then there is an adjustment/tension pin that couples with the "long arm" on the rear bearing cap of the Tcase, and a "short arm" under the above mentioned post arrangement.
When the "long arm" is pulled by the hand brake lever, it pulls the top of the shoes toward the drum, and the bottom of the shoes touch the drum based on the adjustment of the two screws.

 

http://community.webshots.com/user/jpflat2a
click on hand operated parking brake
click full size for closeup view

 

Thanks Jim, the site is fantastic!! Kelly