1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Buick v6 identification

Discussion in 'Early CJ5 and CJ6 Tech' started by Mike S, Oct 19, 2009.

  1. sbaker

    sbaker New Member

    Here are the photos of my distributor lobes. I can't really tell but they do not appear even so does that mean I have an odd fire?


    IMG_8887.JPG IMG_8889.JPG IMG_8890.JPG IMG_8891.JPG IMG_8892.JPG IMG_8893.JPG
     
  2. tarry99

    tarry99 Member

    3-Long flat lobes and 3 shorter ones = Odd Fire........fires at 90-150 degrees
    6-equal lobes = Even Fire..........fires 120 degrees
     
  3. sbaker

    sbaker New Member

    Here is a crude diagram of my distributor's cams (or lobes). The high points are exaggerated for the illustration but note that they are all evenly spaced apart and three of the high points are clearly wider than the other three. From what I'm hearing, this is an odd fire 231 V6. Can someone second this before it goes to a vote????

    IMG_8909.JPG
     
  4. Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    The lobes you have drawn are for ODD-FIRE and the 1254083 translates to 1977 231 OF as stated above. (as well as others)
     
  5. sbaker

    sbaker New Member

    Thank you everyone! I never would have figured it out without you!
     
  6. nickmil

    nickmil In mothballs.

    Unless the engine came from a marine or industrial application you can bet if the engine has a points distributor it's an oddfire since GM used HEI in pretty much all the passenger vehicle 231's from it's common use in '75 and newer. I'd say someone probably installed a 225 distributor in a 231. Mid '77 is when the change from odd to evenfire happened. I've owned both even and oddfire '77 engines.
    Check and see if your distributor cap has a metal tab that slides up to open up a "window" to adjust the points. If it does it should be a Delco distributor (a good thing). If not then a Prestolite distributor. This important for ordering correct tuneup parts like points, cap, rotor, etc.
     
  7. Mcruff

    Mcruff Earlycj5 Machinist

    At first I thought that was a cast iron body, but I don't remember my Prestolite having the centrifugal weights on top like that. It must be a Delco unit.
     
  8. Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    His post #13 shows a Delco cap and a picture in post #21 shows a breaker plate with a Delco part number. Looking at all those pic's, it looks like that distributor has a lot of wear.
     
  9. sbaker

    sbaker New Member

    My CRT Performance HEI arrives today. The rush was that I ordered it thinking I had a Dauntless but then started to figure out that I didn't. Thankfully, the HEI I ordered works on the 231 odd fire also!
     
  10. sbaker

    sbaker New Member

    And in less than 12 hours, whatever distributor that is will be thrown in the garbage and never spoken of again!