Msd ignition box

Just installed a digital msd ignition box and a new coil on my stock motor...I want to share with you all how much this small change dramatically improved the performance of my jeep.
On a cold morning the jeep used to go through stages of warming up, from a high idle to medium them finally once warm a low 700-800 rpm idle..if I didn't let my motor go through these stages it would stall and hesitate making a restart necessary...
NOW it starts and stays running at a low rpm all the time.....my acceleration is smooth with no flat spots and no hesitation even when cold....

Just thought some of you might appreciate knowing for about $250.00 you could breath new life in your old jeep...

 

I agree. Did it to my 304. I put mine on the passenger fender well.


Sent from my iPhone using Tapatalk

 

Nice.. Thanks for the report!!

 

Thanks for the report, I've been debating on which route to go for ignition. Which specific model # did you use for the box and coil?

 

"this small change dramatically improved the performance of my jeep."

Was the stock ignition in a good state of tune when you made the comparison?

 

I used an msd 6A ignition box and a msd blaster II coil

Yes my jeep is a daily driver and ran fine before this swap....now it runs even better......timing remained the same and carb wasn't touched..