1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

skinny springs on wide pads

Discussion in 'Flat Fender Tech' started by cjsammyowner, Jan 14, 2012.

  1. cjsammyowner

    cjsammyowner Member

    Is it safe to run the skinny 1.75" wide springs on a 2.5" wide spring pad? I'm guessing if its ok I would need to run the 2.5" spring plates?
     
    cjsammyowner, Jan 14, 2012
    #1
  2. nickmil

    nickmil In mothballs.

    The problem with that is when you torque the u-bolt nuts it will bow the ubolt plate. The flexing driving down the road can stretch the u bolts, overstress the mounting plate, and cause the ubolts to deform the axle housing. You really should match the spring pad width to the spring width to be safe.


    Sent from my iPhone using Tapatalk
     
    nickmil, Jan 14, 2012
    #2
  3. cjsammyowner

    cjsammyowner Member

    Thanks nickmil, Thats what I thought. Guess it was wishful thinking to just use my stock springs.
     
    cjsammyowner, Jan 15, 2012
    #3
  4. ralf

    ralf New Member

    Check out the wanted section of the CJ2A forum. I am sure there are a lot of them around to be had cheap.

    $8 to $12 on Epay
     
    ralf, Jan 16, 2012
    #4