1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

vvviiiibbbrrraatiiiiooonnn????

Discussion in 'Early CJ5 and CJ6 Tech' started by Rockin 66, Jan 1, 2006.

  1. Rockin 66

    Rockin 66 Rockin 66

    As many of you know I threw my rear drive shaft on Thanksgiving...Welll I found one from J&W Jeep and put it on. Well there was this strange noise and a slight vibration. I took it off reversed it 180 degrees and tried again. Still noise and vibration at about 20 mph. Took drive line off again and took to driveline guy to have it balanced. Driveline guy says its good to go nothing is wrong with it..... Anybody know WTF is going on??? What could I damage by blowing a ujoint and losing a drive shaft?:evil:

    Thanks(OlllllllO)
     
    Rockin 66, Jan 1, 2006
    #1
  2. ilovemyjeep

    ilovemyjeep 1971 CJ-5 w/ Dauntless V6

    Might want to double check your ujoints. They might not be seated quite right... had that problem on my f150.
     
    ilovemyjeep, Jan 1, 2006
    #2
  3. Boyink

    Boyink Super Moderator Staff Member

    Make sure you're not in 4WD.
     
    Boyink, Jan 1, 2006
    #3
  4. 181jeep

    181jeep Banned

    make double sure that the slider is in correct time. Can't believe either you or the drive line guy hasn't checked but sometimes easy things get overlooked.

    JB
     
    181jeep, Jan 1, 2006
    #4
  5. 80cj

    80cj Member

    Did you do something to change the angles on the transfer case or rearend?
     
    80cj, Jan 2, 2006
    #5