1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Rear Axle Bearings

Discussion in 'Intermediate CJ-5/6/7/8' started by Jeepsterjim, Oct 11, 2020.

  1. Jeepsterjim

    Jeepsterjim Member

    I'm ready to install new axle bearing kits in a 1971 d-44 flanged rear diff. I bought dana bearing kits to do this job.

    I wanted to pull the cone and cup apart so as to pack the bearings but for some reason I can not get them to separate so I can pack the cone. Any thoughts?
     
    Last edited: Oct 11, 2020
    Jeepsterjim, Oct 11, 2020
    #1
  2. Ohiowrangler

    Ohiowrangler Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    If they aren't sealed, you can use a needle adapter on your grease gun. It'll be able to get grease into the rollers. Ron
     
    Ohiowrangler, Oct 12, 2020
    #2
  3. sterlclan

    sterlclan Member 2024 Sponsor 2022 Sponsor

    The cone is bonded on somehow on a new bearing. I drilled the housing for a grease fitting and grease them there.
     
    sterlclan, Oct 12, 2020
    #3
  4. jpflat2a

    jpflat2a what's that noise?

    They will separate after installation and use.
    I have used a shop rag.
    Liberally apply grease to the open side.
    Pulling tightly on the shop rag from both ends, use the shop rag to force the grease into the bearing.
    Continue working it around until till it's packed.
     
    jpflat2a, Oct 12, 2020
    #4