1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Some Woodshop Today

Discussion in 'The Tool Shed' started by plastikosmd, Feb 24, 2019.

  1. plastikosmd

    plastikosmd Member

    First, double checked the TS miter for true-ness with 1-2-3-4-1 cut. Caliper indicates within square, dead true.
    [​IMG]

    Then started some cedar coasters from some scrap. I’m not sure if I will cork the backs after epoxy fill
    [​IMG]
    [​IMG]
     
    plastikosmd, Feb 24, 2019
    #1
    mortten, Bowbender, ITLKSEZ and 2 others like this.
  2. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    I like that jig.
     
    PeteL, Feb 24, 2019
    #2
  3. plastikosmd

    plastikosmd Member

    Thx
    It is some old tablesaw miter, I think it is for endcuts on tenons

    I have to cut some smaller angle pieces to hold the stock so I can keep trimming off sections
     
    plastikosmd, Feb 24, 2019
    #3
  4. mortten

    mortten I can’t put my finger on it 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Yeah that’s a tenoning jig.
     
    mortten, Feb 27, 2019
    #4
  5. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    I figured that, but the application was novel to me.
     
    PeteL, Feb 27, 2019
    #5