-
Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.Dismiss Notice
FinoCJ's Recent Activity
-
FinoCJ liked Oldpappy's post in the thread WTB 11" Bendix Backing Plate With Park.
As long as they are not bent those should work fine.
May 22, 2024 at 11:23 PM -
FinoCJ liked Fireball's post in the thread Fino's 58 Wagon.
I would start at the bottom since that seems to be where the problem is. Pull the #1 cap and inspect the bearing. If it's bad, then...
May 22, 2024 at 11:14 PM -
FinoCJ replied to the thread Fino's 58 Wagon.
Well....I think I identified the engine knock I've been chasing for a year. Its finally gotten loud enough that I could use a...
May 22, 2024 at 10:28 PM -
FinoCJ replied to the thread WTB 11" Bendix Backing Plate With Park.
So I bought the pair shown above.... there were/are rough.....really they needed sandblasting, but various wire wheels etc got them...
May 22, 2024 at 10:03 PM -
FinoCJ replied to the thread Blower Motor Replacement.
I was just in Salmon ID downstream a (longish) ways from Stanley....its not that cold anymore....If I bring the CJ, I'll be open top...
May 21, 2024 at 8:45 PM -
FinoCJ replied to the thread Blower Motor Replacement.
Blazer blower swap....can be done on ecj5, intermediate and later CJ as well as YJ.....think the blower is PM102.....search placebo...
May 21, 2024 at 7:07 PM -
FinoCJ liked matt johnson's post in the thread WTB Brake Rod.
Update. Wheelie ( Dave ) supplied us the part. Thanks again Dave.
May 20, 2024 at 10:08 PM -
FinoCJ liked ITLKSEZ's post in the thread Varg In Jeep's Clothing.
Seat belt retractor, part one. The seat belt mechanisms I'm using are a bit backwards for my application. Because the were mounted...
May 16, 2024 -
FinoCJ liked Keys5a's post in the thread Swag Press Brake.
Spring for the finger brake version. It is much more versatile when fabbing things up. -Donny
May 16, 2024 -
FinoCJ liked Warloch's post in the thread Swag Press Brake.
I've actually found that I use the flat top more than the regular as I bend more sheet metal than bracket items... at least over the...
May 16, 2024