1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by Keys5a

  1. Keys5a
    Post

    High Performace F Head

    On the back burner, but I intend on refreshing the engine that I have. I want to put a set of forged pistons in it, but they will have to be...
    Post by: Keys5a, May 24, 2024 at 9:36 AM in forum: eBay, FB Marketplace and Craigslist
  2. Keys5a
    Post

    44 Floater

    Thanks! -Donny
    Post by: Keys5a, May 23, 2024 at 10:00 PM in forum: Early CJ5 and CJ6 Tech
  3. Keys5a
    Post

    Four Cylinder Repacement Fuel Pump Issues

    This video is a classic example of way you don’t toss those old worn out parts in the trash bin. They are made better than the new crap parts that...
    Post by: Keys5a, May 23, 2024 at 12:20 AM in forum: Early CJ5 and CJ6 Tech
  4. Keys5a
    Post

    Transmission And Transfer Case Oil

    Though motor oil might meet a protection spec, you want to run a 90 weight GL4 gear oil in your CJ. I have a car that run sae 30 motor oil, and...
    Post by: Keys5a, May 22, 2024 at 11:00 PM in forum: Early CJ5 and CJ6 Tech
  5. Keys5a
    Post

    Lost Oil Pressure

    Wise move on pulling the timing cover to throughly check the oil pump and the rest o& everything else. Yes, it looks like you loosened the...
    Post by: Keys5a, May 22, 2024 at 10:49 PM in forum: Early CJ5 and CJ6 Tech
  6. Keys5a
    Post

    44 Floater

    Can I ask for a measurement on the length of the axle shafts? Assuming they are 19 spline inner/27 spline outer? I collecting parts to build one...
    Post by: Keys5a, May 22, 2024 at 10:24 PM in forum: Early CJ5 and CJ6 Tech
  7. Keys5a
    Post

    Engine Tooling

    I have a similar (older) Sunnen guide hone, and it works well. I also have a setup that sleeves the original worn guide. I ream the worn guide,...
    Post by: Keys5a, May 22, 2024 at 9:51 PM in forum: The Tool Shed
  8. Keys5a
    Post

    Growler

    Looks like 73 CJ5 has a growler in his collection of machine tools (see “Engine Tooling”). -Donny
    Post by: Keys5a, May 22, 2024 at 9:34 PM in forum: The Tool Shed
  9. Keys5a
    Post

    My Old Millermatic 35 Feed Motor Has Died...

    I would still look for a NOS or used feed motor. The old machines weld so much better than the newer machines, in my opinion. I think is has to do...
    Post by: Keys5a, May 22, 2024 at 9:21 PM in forum: The Tool Shed
  10. Keys5a
    Post

    Engine Tooling

    I also have a number of engine machine shop tools/machines, many Kwik-Way branded. I have a couple of those electric valve seat grinders, and...
    Post by: Keys5a, May 22, 2024 at 9:03 PM in forum: The Tool Shed
New Posts