I'd make sure the mounts are in good shape and then just get what you have reupholstered. They'll look the part.
You can see in this closed ebay auction how the mounts are supposed to look. https://www.ebay.com/itm/145742316473
It's a 76+ rear seat. The stock cj5 rear seats were within a inch of so of the tailgate or tailpanel. The front seats are not original and the...
3-4th is back to normal!
Im spent.. Just wore out! This weekend I made a Highly engineered <= Fabricobbled Bracket that utilized the t18 to d20 adapter side vestige...
Yep. Grab the wix. 51258
Correct. The later seats like he was looking at also has front floor mounted brackets that allow it to pivot. The 72-75 brackets are not the...
Do you have a pic of the wheel well brackets? I think that seat uses just floor brackets. Wheel well brackets might be for an aftermarket rear seat.
I just used The cheap half back seats sold on ebay or amazon. I flipped them over and re drilled the underside of the passenger seat frame using...
Keep in mind, If you do go to stock springs you'll need to take out the spacers in the transmission cross member. I think there are 2, sometimes...
The Taper shims realign the pinion angles to the correct angle after lift springs have been installed.
I have torn the Hydro setup I have off and am starting anew. It's really been bothering me that I am so close to getting this thing back on the...
Body swap? Or possibly a early 75 tub titled as a 74?
You'll need to get stock height springs if you want to lower it down. The shackles really aren't that tall and wont do much if you went to stock...
The correct fuel fill and vent hose and hardware is below. It looks like they used the factory fill neck in your current setup You'll need that...
Separate names with a comma.