1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Changing the clutch

Discussion in 'Intermediate CJ-5/6/7/8' started by walterv, Dec 22, 2004.

  1. walterv

    walterv Member

    What's the easiest way to change the clutch and throw-out bearing? Pull the moter or dropping the bell housing/tranny/t-c combo?

    edit: It's a 75 w/304 t15
     
    walterv, Dec 22, 2004
    #1
  2. jpflat2a

    jpflat2a what's that noise?

    if it were mine, dropping the trans/transfer case would be the prefered way for me
     
    jpflat2a, Dec 23, 2004
    #2
  3. Jeepenstein

    Jeepenstein Me like Jeep.. 2024 Sponsor

    6 0ne way half dozen the other.. I'd go the t case/tranny way but I've got mine set up a bit easier to remove with my custom cross member...

    BUBBA
     
    Jeepenstein, Dec 23, 2004
    #3
  4. walterv

    walterv Member

    Thanks guys, that's the way it came out. Actually, got a late start on it today. it's on the garage floor waiting to go back in. should finish up tomorrow.
     
    walterv, Dec 23, 2004
    #4