1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

What size is the bolt in between the T90 and bellhousing?

Discussion in 'Flat Fender Tech' started by BrenGun, Nov 27, 2009.

  1. BrenGun

    BrenGun Just Some Guy

    It "feels" like a 1/2" but before I go out and buy a wrench to get in there (or drop a socket in there...R)) I'd like to find out for sure. Anyone know? Its the bolt at the top of the T90 case with the head inside the bellhousing. TIA
     
    BrenGun, Nov 27, 2009
    #1
  2. jpflat2a

    jpflat2a what's that noise?

    :?
    all the bolt heads are on the trans case side
    that is, the bolts that hold the trans case to the bellhousing
    should be no bolt head inside the bellhousing
     
    jpflat2a, Nov 29, 2009
    #2
  3. w3srl

    w3srl All-around swell dude Staff Member

    I was wondering about that also, I've never seen one bolted from the inside. With everything bolted up I can't see how you woudl have enough room to get a tool on it from that teeny inspection port in the T-90 bellhousing.
     
    w3srl, Nov 29, 2009
    #3
  4. BrenGun

    BrenGun Just Some Guy

    My bad. I was having problems removing the bellhousing and the T90 from one another and the only thing that I could figure out was what appeared to be a bolt sticking through the T90 case with what I could only figure as the bolt's head inside the bellhousing. I couldn't remove the bellhousing from the engine either, so that compounded the problem, because I couldn't tell. It obviously wasn't that bolt that was causing my problem. That bolt is only holding on an outer flange to the T90. I had just figured that it was going to be some exotic Willys-Overland bent wrench that I would have to somehow find. :)
     
    BrenGun, Nov 29, 2009
    #4