Header Questions. 231 V6

Finally got around to adding the block hugger headers and ran into this issue. Anyone know what I can do about it?

Im thinking a 90 then into the brake line. I don’t know the size of the line.

The passenger side bolts up fine but is touching the motor mount bracket. Is that something I should worry about and is there a way to fix that?

 

I'm not sure I like having heat that close to the master cylinder.

 

can't really tell in photo
but most single master cylinders . have the fitting held with a banjo bolt with crush washers
if so just rotate it around

 

ditto above
just loosen and rotate.

 

Awesome. I’ll give that a shot.
Thanks!

 

After it’s all done I’ll put a heat shield of some sort between it. Try and keep some of the heat off it.

 

install swing pedal set up?

 

Eventually. Trying to get it back up and running.

Now that I have the headers figured out I can move forward with putting it back together.

I have to figure out the carb linkage now.

A swing pedal might be soon anyways.