1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

F-head Valve Cover Question

Discussion in 'Early CJ5 and CJ6 Tech' started by modadds, Oct 22, 2019.

  1. modadds

    modadds New Member

    What is everyone using as the rubber washer that goes under the nut and flat washer that holds their F-head valve cover on. Mine was falling apart when I took the valve cover off to rebuild it. No one shows that part in any of the catalogs or Jeep supply houses. There is two per valve cover.
     
    modadds, Oct 22, 2019
    #1
  2. baldjosh

    baldjosh Member

    My rebuild kit came with 2 small gray fiber washers...I wasn't really sure what they were for so I used those...they don't leak, and don't deform. Ive seen similar at Ace hardware...
     
    baldjosh, Oct 22, 2019
    #2
  3. timgr

    timgr We stand on the shoulders of giants. 2022 Sponsor

    You can buy rubber sealing washers at McMaster-Carr McMaster-Carr
    Possible you can buy individual washers from the parts drawers at an Ace Hardware.
     
    timgr, Oct 22, 2019
    #3
  4. Rick Whitson

    Rick Whitson Detroit Area 2024 Sponsor 2022 Sponsor

    Welcome from Michigan, Modadds. I bought a complete gasket kit for my motor and I think they came with it. You should buy a complete gasket set, that way you will always have what you need. Just a suggestion, Good Luck
     
    Rick Whitson, Oct 23, 2019
    #4
    65CJ5 SRD likes this.