1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Sm420

Discussion in 'Builds and Fabricators Forum' started by Ole Al, Jul 18, 2018.

  1. Ole Al

    Ole Al New Member

    Started 420 install today. Friend has a lift,
    Makes it a little easier and I am too old to
    be crawling around on the ground. Anyway got everything out and ready to
    start installing new tranny tomorrow.
    Anyone know of a good driveline shop in
    Colorado Springs ?
     
    Ole Al, Jul 18, 2018
    #1
  2. Warloch

    Warloch Did you say Flattie??? Staff Member

    I've had spotty luck in the last few years so I moved on to using Tom Woods off the net. Like the longer stroke you can get that way for the setups.
     
    Warloch, Jul 19, 2018
    #2
  3. melvinm

    melvinm Member

    Front Range Driveline Inc.
    4000 So. Federal Blvd.
    Englewood Co. 80110

    Phone 303-783-9954

    Talk to Jim or Brian

    They Did My drive shafts front and rear , also did the ring and pinion in the front axle.
     
    melvinm, Jul 19, 2018
    #3
  4. Muzikp

    Muzikp Active Member

    I had to modify the opening in my floor to fit the SM420 in mine. I've heard some people have clearance issues with the front driveline and the hump on the side of the SM420, although not sure why since mine clears by several inches.

    Here's how much of my floor ended up getting cut

    [​IMG]

    And here's the cover I made for it afterwards.

    [​IMG]
     
    Muzikp, Jul 19, 2018
    #4
    tymbom and melvinm like this.
  5. heavychevy

    heavychevy Sponsor

    Great looking install. Sm420 has a super low gear.
     
    heavychevy, Jul 19, 2018
    #5
  6. Ole Al

    Ole Al New Member

    While I'm at it decided to take a look at the
    xfer case. Everything looks good, intermediate shaft looks new. Discovered
    rearend has a powerlock. The more I crawl around on this old Jeep the more I
    find to like about it. 4.88s, powerlock,
    Holly manifold, eldebrock 1404, pwr steering.
    Gotta get this 420 in and update the brakes.
    This is my first CJ, I'm stoked!
     
    Ole Al, Jul 19, 2018
    #6
  7. Ole Al

    Ole Al New Member

    Hey guys, any advice on how to remove
    Warn of from T 86 main shaft???
     
    Ole Al, Jul 20, 2018
    #7
  8. Ole Al

    Ole Al New Member

    Never mind , got it.
     
    Ole Al, Jul 20, 2018
    #8