1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Radio Mount

Discussion in 'Builds and Fabricators Forum' started by Jeremy Knakmuhs, Jul 13, 2018.

  1. Jeremy Knakmuhs

    Jeremy Knakmuhs Jknakmuhs

    Our 68' CJ5 currently has a old Ford radio installed that no longer works. The PO cut the dash and the existing radio just clips into the cut-out. It is a very loose connection though. Anybody know of an actual radio mount that I could install to give a new radio a little more stability? Thanks in advance.
     
    Jeremy Knakmuhs, Jul 13, 2018
    #1
  2. piffey263

    piffey263 Active Member

    I put mine in the glove box,

    I made it out of galvanized steel and rivets. This way it has something structural and is fully supported.

    My blazer was set up in dash like you mentioned. If you want to retain the hole in the dash. Use a piece of plumbing strapping. (Metal with bunch of holes.) then boot it to the back.
     
    piffey263, Jul 14, 2018
    #2
    Jeremy Knakmuhs likes this.