1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Doh!!! Dumb Dumb Dumb. Can I??

Discussion in 'Flat Fender Tech' started by DanStew, Jan 25, 2017.

  1. DanStew

    DanStew Preowned Merkin salesman Staff Member

    I torqued down everything after putting the new headgasket in ......

    But I forgot to put the crossover tube over the studs before putting the nuts on.

    Can I just undo those two nuts and put the tube on and retorque without any problems? Or loosen them all and have back at it? I have not run the motor yet if that makes a differences.

    Thanks
     
    DanStew, Jan 25, 2017
    #1
  2. Howard Eisenhauer

    Howard Eisenhauer Administrator Staff Member

    I've loosened off individual (or two head bolts) at a time & no problems after re-torquing them.

    H.
     
    Howard Eisenhauer, Jan 25, 2017
    #2
  3. DanStew

    DanStew Preowned Merkin salesman Staff Member

    Thanks!!
     
    DanStew, Jan 25, 2017
    #3
  4. DHill78

    DHill78 Sponsor

    Correct. As long as no pressure, is applied to the heads, loosing studs a couple at a time isn't going to hurt a thing.
     
    DHill78, Jan 26, 2017
    #4