1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

The Official "What The Heck Is This?" Thread

Discussion in 'Early CJ5 and CJ6 Tech' started by Focker, Feb 19, 2016.

  1. 47v6

    47v6 junk wrecker! 2023 Sponsor 2022 Sponsor

    ah, i have never actually seen a v6 throttle setup.
     
  2. Twin2

    Twin2 not him 2024 Sponsor 2023 Sponsor 2022 Sponsor

    x2
     
  3. Don X

    Don X The Prodigal Moderator Staff Member 2023 Sponsor

    My engine stay is threaded on the engine end and goes through one of the bell housing bolt holes. The nut on the threads are the way mine is adjusted.
     
  4. Steve's 70-5

    Steve's 70-5 Active Member


    Here are a couple pictures of V-6 throttle setup. These are from Matt's Jeep

    Here is the linkage on the firewall

    [​IMG]

    Here is how the arm comes thru the firewall

    [​IMG]
     
    47v6 likes this.
  5. mickeykelley

    mickeykelley Well-Known Member

    There is a canvas tube sheathing around the wire that goes to the fuel tank sending unit and that runs under the frame to the taillights. What is the official name for that and where can I buy it by the foot? Thanks in advance.
     
  6. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

  7. Beach66Bum

    Beach66Bum 1966 Tuxedo Park Mark IV 2024 Sponsor

    Since when does Summit Racing not ship to Canada?! I've bought from Summit before for another vehicle, this is new news.
     
  8. cpdad93

    cpdad93 Member

    jeep9.JPG not sure if this is the right way to post on this thread....I have these two plumbing fittings on the backside of the front bumper...any hints?
     
  9. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor


    For refilling the blinker oil.

    Or maybe mounts for parade flags???
     
    Kodiak80 and Mark T. like this.
  10. cpdad93

    cpdad93 Member

    They are about the right size to hold an emergency snifter of whiskey
     
    Kodiak80 likes this.
  11. sterlclan

    sterlclan Member 2024 Sponsor 2022 Sponsor

    For adding bumper oil of course
     
    Kodiak80 likes this.
  12. cpdad93

    cpdad93 Member


    do you think the synthetic is better or a waste of $$$$$
     
    Kodiak80 likes this.
  13. Twin2

    Twin2 not him 2024 Sponsor 2023 Sponsor 2022 Sponsor

    it's a jeep . got to have the good stuff :rofl::rofl::rofl::rofl:
     
    Kodiak80 likes this.
  14. ITLKSEZ

    ITLKSEZ Hope for the best, prepare for the worst

    Are they just welded to the back of the bumper, or do they go through?
     
  15. Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    I agree with this.
     
    Rich M., PeteL and ITLKSEZ like this.
  16. ITLKSEZ

    ITLKSEZ Hope for the best, prepare for the worst

    Or for removable mounts for rod holders? Are you in a big fishing locale?
     
    Kodiak80 likes this.
  17. schneedrache

    schneedrache New Member

    What is this tray for? Not my frame in the picture, but I have the same thing on my '57 CJ5

    [​IMG]
     
    Mark T. likes this.
  18. 45es

    45es Active Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Battery mount.
     
  19. schneedrache

    schneedrache New Member

    Hmmm...OK, my battery was mounted to the firewall so I was unsure.
     
  20. mickeykelley

    mickeykelley Well-Known Member

    Somebody moved it. It belongs on that tray.