1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Driveshaft repair

Discussion in 'Early CJ5 and CJ6 Tech' started by ljspop, Jan 19, 2005.

  1. ljspop

    ljspop Lurking Bronco Dude

    Hiya,

    I have an opportunity to trade a member here my small yoke V6 fron DS for a big yoker that'll work with my D30. Problem is on the DS he has the end-cap/retainer oil seal deal is rusted/blown out. Are these available anywhere?

    Thanks!

    Bob
     
    ljspop, Jan 19, 2005
    #1
  2. 66cj5

    66cj5 Jeep with no name

    try flaps or one of the jeep parts houses. also a driveshaft shop might have one.
     
    66cj5, Jan 19, 2005
    #2
  3. 53Flattie

    53Flattie Intigator

    Bob - I'm not sure I know which part you're talking about...

    The little piece that "sweeps" the grease off the splines when the DS extends and collapses? Looks like a ring with teeth on it to fit inside the splines?
     
    53Flattie, Jan 19, 2005
    #3
  4. ljspop

    ljspop Lurking Bronco Dude

    That's OK Tim, I'm not sure I know what I'm talking about :rofl:

    I've attached a pic. Basically whatever keeps the grease in and keeps the shaft from falling apart when it is disconnected is shot.

    I can just call around - but wanted to know what I was asking for.

    Thanks guys -
     
    ljspop, Jan 19, 2005
    #4
  5. vanguard

    vanguard

    Bob, You might try giving Drivetrain specialties in El Cajon a call. They made my rear driveshaft after MIT said my original was shot.
     
    vanguard, Jan 19, 2005
    #5