Jackdog, spent a couple hours today and replaced the front axle shims. Upon inspection, I had the 2 deg shims that came with my 4" lift kit in...
Curious what you find, my commando wanders at speed also. I've replaced the saginaw box, springs, lower and upper steering shafts, tie rod ends....
Is there a better Housing Cap for the Tremec T176 than the Crown part # J8134667? I would rather something machined or forged, the stamped steel...
Question, does the Lower Steering Shaft (Part # 999-714) for a 1973 C104 Jeep Commando with Power Steering supposed to have a slide joint in it?...
I routinely use my block heater in my Duramax in Houston during January/February for the comfort factor, and as I get older, that comfort factor...
Was troubleshooting the aftermarket tachometer which stopped reading and discovered that if the signal wire from the HEI distributor to the Tach...
Any of you install an engine block heater in your commando, specifically the :amc: AMC 304? I will admit, I live in Houston, and it doesn't get...
Anybody with a Parts Commando that has the original seat supports they feel like selling? A PO installed bucket seats in my 73, looking to...
There is currently one on ebay. jeepster commando switch panel all switches function jeep commando | eBay
No rubber pad between the axle and springs. The bushings are all new along with the springs, though they might need to be retorqued now that I've...
Separate names with a comma.