It would seem to me that if the axle shaft is 1.250 on the outer splined end you could just install the axle into the housing first then install...
This is going to be a good thread! (y),I am learning a lot. I appreciate your time posting. :watch:.
x3, Another vote for stengel bros.
Ah, thanks guys.
Thankyou, does the shoulder of the spindle need machined as well to fit inside where the wheel bearing once was in the axle housing? Apologies for...
Sounds like at least a removal of the timing cover to examine the gears and oil pump shaft for free movement plus clean out any metal shavings. As...
Really nice find. Congratulations. Was wondering how much machining was required to convert the dana 30 spindles? if you know.
Was just reading thru your thread. Do you have air conditioning with an AC condenser in front of your radiator? I can see the under dash unit.
Separate names with a comma.