I am trying to pull transfer case to rebuild but i cannot get the speedometer cable of it, am I missing something, shouldn't you just unscrew the...
Ok, I have got to remove the Dana 20 to rebuild it, i cannot get it to shift at all and read some where it needs to be in neutral ! Not sure if...
To be honest I do not know which box I have, I just purchased this jeep and really haven't had a chance to fully inspect it besides the obvious...
It is power steering and i have replaced all steering components that was needed, main issue was the shaft, shackles were loose but still slow...
My steering is aweful as far as how many times you have to turn steering wheel to turn, seems like it takes 20 turns to be full locked and that is...
Ok, so I have decided on getting rid of the SOA and going with Old Man Emu YJ conversion, hoping everything lines up and works (steering geometry,...
Not really needing that much lift really, I am just trying to figure out which way to go, I know I will have to cut and re weld spring perches on...
I have a '73 CJ5 that is currently a SOA setup, it is a bear to get in and out beings it has a full rollbar and aftermarket seats (out of some...
I am currently debating this issue as well, I have SOA conversion and my springs are shot, they are flat and sitting on 35" tires. Was gonna drop...
no they did not, this is a '73 CJ5, both sides are sitting hard on these stops, I can see where there should be placed on frame, don't know why PO...
Herer is the bump stop I was referring to[ATTACH]
Separate names with a comma.