1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by Rich M.

  1. Rich M.
    Post

    Timing Cover

    Sure it's not a 198?
    Post by: Rich M., Apr 25, 2024 at 9:40 PM in forum: Early CJ5 and CJ6 Tech
  2. Rich M.
    Post

    Weber Dgav Carb On A 258 Engine

    Highly suggest you contact Sal Walter @ Vintage Jeeper. He deals/ sets up Weber carburetors for Jeeps and is highly knowledgeable.
    Post by: Rich M., Apr 24, 2024 at 9:45 PM in forum: Intermediate CJ-5/6/7/8
  3. Rich M.
    Post

    For Sale 231 Timing Cover, Oil Pan, Balancer And Pulleys

    I'd take the front cover.
    Post by: Rich M., Apr 24, 2024 at 8:24 PM in forum: Early CJ-5 and CJ-6 Classifieds
  4. Rich M.
    Post

    For Sale 231 Timing Cover, Oil Pan, Balancer And Pulleys

    Even ,the rest of it is laying on my garage floor.
    Post by: Rich M., Apr 24, 2024 at 8:23 PM in forum: Early CJ-5 and CJ-6 Classifieds
  5. Rich M.
    Post

    Let's Nerd Out On Some Calculations

    .7 @ 600 rpm ( about as low as it likes to go, I have lugged it to 3-400 occasionally)
    Post by: Rich M., Apr 24, 2024 at 5:13 PM in forum: Builds and Fabricators Forum
  6. Rich M.
    Post

    Dana 300 Or Not??

    That's what's in my project flatfender. Th350/D300. Most have a free trashlock too.
    Post by: Rich M., Apr 22, 2024 at 8:59 PM in forum: Builds and Fabricators Forum
  7. Rich M.
    Post

    71 Wheeling Rig

    So Rubicon ready ? :whistle:
    Post by: Rich M., Apr 22, 2024 at 8:56 PM in forum: Builds and Fabricators Forum
  8. Rich M.
    Post

    Fuel Pump

    This will be my solution to my crappy running 360...
    Post by: Rich M., Apr 21, 2024 at 4:56 PM in forum: Intermediate CJ-5/6/7/8
  9. Rich M.
    Post

    Let's Nerd Out On Some Calculations

    An automatic makes much of this moot. There's a reason I have an amc th400 with a 300 adapter on the floor right now
    Post by: Rich M., Apr 20, 2024 at 3:21 PM in forum: Builds and Fabricators Forum
New Posts