It's been a couple years, but I think I used a universal Mr. Gasket valve cover grommet plug and then carefully cut the plug part to fit the...
I got my dwell meter in the mail, so i was finally able to set everything. The dwell was 17-18 degrees, so 12-13 degrees off. When I adjusted...
I was able to take the jeep for a quick drive today to see how the new timing was. (I didn't mess with the dwell or points yet) It seemed to run...
At some point I would like to run a DUI setup and we can argue the finer points of different ignition setups at a later date. My goal this summer...
Ok sounds good. They were changed in 2012 and probably only have 1000 miles since then due to other projects i was working on.
Got it. I will try to do that next. If we assume it was set properly before, can that change over time?
Not sure on the advance weights. I do know it has vacuum advance, so would it also have advance weights? (I did unplug the vacuum line to the...
So I was able to check the timing with the new light. It was around 15 degrees out. I brought it down to 5 degrees and the engine slowed down to a...
Thanks, was just reading the chilton's manual i have and they mentioned painting it white. I was going to use a silver sharpie, but white out is...
Will do. Makes sense. Thanks.
Thanks. Should I hold off on buying all 6 plugs and just replace the broken plug while I adjust the timing then check again to see if I need...
Thanks for the input! I will get a timing light and check that. Forgive my ignorance, but as the timing chain wears in/stretches, will that mean...
I didn't do the timing before, so it isn't something I am familiar with, but I will do that. It is a 225 motor. I was going to make a trip to...
After a bit of research, I am assuming that I am getting detonation or pre-ignition. I am going to try out two things to start: 1. Higher Octane...
Hey all, I am hoping someone has a good ear and can take a listen to this. I noticed it yesterday when I had to slow down on a 15% incline in...
Separate names with a comma.