-
Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.Dismiss Notice
Ol Fogie's Recent Activity
-
Ol Fogie replied to the thread Fan Blade Question.
Was just reading thru your thread. Do you have air conditioning with an AC condenser in front of your radiator? I can see the under dash...
May 17, 2024 at 12:33 PM -
Ol Fogie liked Rozcoking23's post in the thread Fan Blade Question.
The water pump is right at a year old, it’s a FlowKool unit. It’s running about 5-7* cooler then the original/stock water pump.
May 17, 2024 at 12:30 PM -
Ol Fogie liked Keys5a's post in the thread Fan Blade Question.
What condition is your water pump in? I had a truck that only ran hot when running under 15 mph. Heavy steel fan blade in a good shroud,...
May 17, 2024 at 12:30 PM -
Ol Fogie liked duffer's post in the thread Fan Blade Question.
Ahhh, the statistician. Part of my job at the U was looking at data sets from superfund sites (EPA contract) to see how tightly...
May 17, 2024 at 12:27 PM -
Ol Fogie liked Stakebed's post in the thread Fan Blade Question.
I'll offer my advice as a retired sheet metal worker and someone that understands air flow. Your fan blades should be about halfway into...
May 17, 2024 at 12:27 PM -
Ol Fogie liked maurywhurt's post in the thread Fan Blade Question.
I installed an OEM Jeep 7-blade fan on my Dauntless last year, and it pulls a great deal more air and cools noticeably better than the...
May 17, 2024 at 12:24 PM -
Ol Fogie liked Glenn's post in the thread Fan Blade Question.
What's the chance that the coolant flow is too fast?
May 17, 2024 at 12:24 PM -
Ol Fogie liked Rozcoking23's post in the thread Fan Blade Question.
Looking at where the fan sits inside the shroud it is inside it about an inch deeper then the outside lip. Thinking about trimming it...
May 17, 2024 at 12:22 PM -
Ol Fogie liked Rozcoking23's post in the thread Fan Blade Question.
I pulled the radiator out and bolted the fan shroud to it. I’m thinking about cutting it up and extending it down and closing in the...
May 17, 2024 at 12:22 PM
-
Ol Fogie liked Rozcoking23's post in the thread Fan Blade Question.
I have confirmed the temps with my hand held. I’ve considered that the build itself , with the higher compression, over size pistons,...
May 17, 2024 at 12:21 PM