1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice
Warloch

Support Bearing Installed

Support Bearing Installed
Warloch, Dec 18, 2019
    • CHUGALUG
      I'm about a week behind you. I have to get my tub on this weekend then a few other things and I will be doing the shaft I also ran the 525 Saginaw box through the motor mount (CJ-5 Frame 2A ish Tub) I am using an Ididit classic column which is the same D as stock but has a Grant Steering wheel mount on the end. I will be using a Joes Racing Products aluminum 15" wheel with no dish. I like how you did your support bearing. I will most likely do something very similar. My bottom U-Joint has a built in vibration dampener. I'm also going to make an aluminum clamp for the column on the floor. I also made a link type support to the right side frame to help support the output shaft section of the steering box.

      [​IMG]

      [​IMG]
    There are no comments to display.
  • Album:
    Build Examples
    Uploaded By:
    Warloch
    Date:
    Dec 18, 2019
    View Count:
    377
    Comment Count:
    1

    EXIF Data

    File Size:
    1.2 MB
    Mime Type:
    image/jpeg
    Width:
    4608px
    Height:
    3456px
    Aperture:
    f/1.7
    Make:
    OnePlus
    Model:
    ONEPLUS A6003
    Date / Time:
    2019-12-18 16:33:34
    Exposure Time:
    1/33 sec
    ISO Speed Rating:
    ISO 400
    Focal Length:
    4.25 mm
     

    Note: EXIF data is stored on valid file types when a photo is uploaded. The photo may have been manipulated since upload (rotated, flipped, cropped etc).

New Posts