1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

BDS Springs issue

Discussion in 'Early CJ5 and CJ6 Tech' started by djbutler, Jan 16, 2011.

  1. djbutler

    djbutler Sponsor

    Guys,
    I just ordered and picked up from the distributor a new set of BDS springs to go on the '69. Once I had the spring packs unstrapped from the pallet I saw this....
    [​IMG]
    [​IMG]

    The set of front springs have a matching arc, but the rear set do not. There is close to an inch difference in the arc from one rear to the other rear spring.
    I have fired off an e-mail to BDS about it, but got no reply yet as it was Saturday evening. Hopefully by Tuesday I'll get a response from them.

    Has anyone else encountered issues like this from BDS?

    Don
     
    djbutler, Jan 16, 2011
    #1
  2. jeepcj

    jeepcj Member

    I dont know... I had a 4" BDS lift and had no trouble with them or the company. I even had an accident that was non off road related that bent a spring, and as there add states, they replaced it for free. I am sure you will reach or hear from them and the issue will be addressed. I was impressed with there service..
    Good luck and keep us posted..
     
    jeepcj, Jan 16, 2011
    #2
  3. Posimoto

    Posimoto Hopeless JEEP Addict

    Skip emailing them if you want fast response. Give them a call. I'm sure they'll make it right. That's definitely not right.
     
    Posimoto, Jan 16, 2011
    #3
  4. bkd

    bkd Moderator Supreme Staff Member 2022 Sponsor

    x2 ........
     
    bkd, Jan 16, 2011
    #4
  5. Daryl

    Daryl Sponsor

    Are they on the pallet for convenience of the picture? If you set them on a flat surface sitting on the eyes, how far off are they?
     
    Daryl, Jan 16, 2011
    #5
  6. 60sCJ

    60sCJ Jeep Addict

    I'd just put the one with more of an arc on the drivers side to compensate for the notorious Jeep lean.
     
    60sCJ, Jan 17, 2011
    #6
  7. Steve's 70-5

    Steve's 70-5 Active Member

    The Pro Comp springs I got are made the same way
     
    Steve's 70-5, Jan 17, 2011
    #7
  8. djbutler

    djbutler Sponsor

    So, I got ahold of BDS customer service, a fellow named Ted Yearling. He told me that they spec the arc of the springs to match within 1/4 inch. He told me to measure mine using a straight edge placed over the centerline of the mounting holes in the spring eye, then measuring to the top of the spring pack.

    I got measurements of 6" on the flatter of the two, and 6 3/4 on the other. When I talked to Ted again with those measurements he told me the nominal spec is 6 1/8 for those springs, so it sounds like one of them is over arched.
    Using a tolerance of +- 1/8", the springs could be anywhere from 6 to 6 1/4. They are looking through their stock for another one that is at the top end of the range for me.

    Don
     
    djbutler, Jan 18, 2011
    #8
  9. Daryl

    Daryl Sponsor

    I would put the spring with the most arch on the drivers side and run them. They usually settle some once you run em anyways.
     
    Daryl, Jan 18, 2011
    #9