1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

HEADERS WITH HERM'S STEERING KIT

Discussion in 'Early CJ5 and CJ6 Tech' started by rdynes01, Nov 6, 2015.

  1. rdynes01

    rdynes01 Member

    Does anybody know with any certainty which headers for a Dauntless V6 fit a 1967 CJ5 that has ben fitted with Herm's steering kit. I've got the manual version of his kit if that matters and I know fenderwell versions but I'm more interested in whether Novak ones or Advance Adapters ones will fit. Thanks.....Bob
     
    rdynes01, Nov 6, 2015
    #1
  2. rdynes01

    rdynes01 Member

    I also would like to know what the differences are between the Novak V6 headers and the ones made by Sanderson.
     
    rdynes01, Nov 6, 2015
    #2
  3. Warloch

    Warloch Did you say Flattie??? Staff Member

    I have used both header setups, and worked with Eric at Novak designing the ones they sell. They are made by Sanderson, but have been tweeked to fit a V6 in 5s and flatties with both Ross and Saginaw steering. Both sides have slight changes to allow the tubes to clear better, stay in the frame rails, but not crowd the steering and starter.

    I have not used Herm's steering conversion, so I can not comment on it's impacts to fitment.
     
    Warloch, Nov 6, 2015
    #3
  4. 47v6

    47v6 junk wrecker! 2023 Sponsor 2022 Sponsor

    Erik at Novak is excellent to work with
     
    47v6, Nov 6, 2015
    #4
  5. rdynes01

    rdynes01 Member

    What does that have to do with my original question?
     
    rdynes01, Nov 7, 2015
    #5
  6. 47v6

    47v6 junk wrecker! 2023 Sponsor 2022 Sponsor

    nothing other than the fact you could call him, speak to a knowledgeable helpful guy and answer your own question about Novak products.o_O
     
    47v6, Nov 7, 2015
    #6
  7. rdynes01

    rdynes01 Member

    And I appreciate that and if no one here has experience with my situation I will do just that. Thanks....Bob
     
    rdynes01, Nov 7, 2015
    #7
  8. Rob C

    Rob C Member

    I have a set of Hedman headers on my 66 with Herm's steering kit and it clears fine. It's a little close but I was able to make it work. I'm out of town this weekend but will try and post some pictures next week if it would help.
     
    Rob C, Nov 14, 2015
    #8
  9. rdynes01

    rdynes01 Member

    Hedmans are fenderwell headers so they will always fit. I'm interested in inside the frame headers.
     
    rdynes01, Nov 22, 2015
    #9
  10. Rob C

    Rob C Member

    Oh, got you. Guess I should have read your original post closer. Good luck. I'll be following this as I really don't like the fenderwell headers.
     
    Rob C, Nov 24, 2015
    #10