1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Dim headlights

Discussion in 'Early CJ5 and CJ6 Tech' started by B_hester, May 31, 2015.

Page 4 of 4
  1. 47v6

    47v6 junk wrecker! 2023 Sponsor 2022 Sponsor

    GREAT info here.
     
    47v6, Jun 17, 2015
    #61
  2. Glenn

    Glenn Kinda grumpy old man Staff Member

    X2! Something else is going on that is hard to pinpoint apparently.
     
    Glenn, Jun 17, 2015
    #62
  3. Glenn

    Glenn Kinda grumpy old man Staff Member

    Regular sealed beams were adequate before and should still be anyway.
     
    Glenn, Jun 17, 2015
    #63
  4. Glenn

    Glenn Kinda grumpy old man Staff Member

    Did the ground wire already have a ring terminal on it? Is it also the left wire looking from the back, as shown in the diagram?
     
    Glenn, Jun 17, 2015
    #64
  5. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Didn't get 24 volt H4 bulbs, didya? There is such a thing.

    What happens if you plug in a "known good" headlamp?
     
    PeteL, Jun 17, 2015
    #65
  6. B_hester

    B_hester Member

    At this point I don't know what any of the problems are haha I never had good working headlights in it so I can't get a known working one in. As well it very well could be 24 volt I never thought of that! They look like they are running bright enough on the actual lighting and the housing isn't reflecting enough.
     
    B_hester, Jun 18, 2015
    #66
  7. Glenn

    Glenn Kinda grumpy old man Staff Member

    I'm not sure I understand your meaning of the last sentence. The housing isn't meant to reflect any light. The bulbs are sealed beam bulbs.
     
    Glenn, Jun 18, 2015
    #67
  8. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    H4 type is a separate bulb, removable from the reflector. Not sealed beam.
     
    PeteL, Jun 18, 2015
    #68
  9. Glenn

    Glenn Kinda grumpy old man Staff Member

    :oops: Well, I just learned something then. I guess I need a picture to see how that would work in a Jeep.
     
    Glenn, Jun 18, 2015
    #69
  10. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    PeteL, Jun 18, 2015
    #70
  11. Glenn

    Glenn Kinda grumpy old man Staff Member

    Aha! Now I see the light (pun intended). I'm used to just replacing the filament part in the newer vehicles, never paid much attention to what they were. Yeah, if it's still not bright enough something is amiss. Thanks PeteL. :):coffee:
     
    Glenn, Jun 18, 2015
    #71
Page 4 of 4