53A1
Latest activity Postings About
-
-
53A1 reacted to Oldpappy's post in the thread Best approach to lowering gear ratio on a dana 44 (3.75) for wheeling. with
Like.
I have one highly modified trail Jeep. It came to me with all the modifications, some done by the previous owner, most done by various... -
53A1 reacted to cj2atruck's post in the thread Best approach to lowering gear ratio on a dana 44 (3.75) for wheeling. with Like.
Owning/updating an old CJ is a slippery slope. First comes transmission, lockers, etc, for better trail manners, then you start...
-
53A1 reacted to skipilot's post in the thread Best approach to lowering gear ratio on a dana 44 (3.75) for wheeling. with Like.
Just remember that since you have a ‘71, it should have a T14 with the 10 spline output. Everything else was a 6 spline. Since anything...
-
53A1 replied to the thread Best approach to lowering gear ratio on a dana 44 (3.75) for wheeling..Mine had a little water. I rinced with old gas (not recommended by most - diesel/kerosene is safer.). If it sat upright the reverse gear...
-
53A1 reacted to Dana44's post in the thread Best approach to lowering gear ratio on a dana 44 (3.75) for wheeling. with Like.
Its 6-ish to 1. See the piece of wood showing a bit over 6 revolutions counted input to attain 1 at output in 1st gear. The shifter...
-
53A1 replied to the thread Best approach to lowering gear ratio on a dana 44 (3.75) for wheeling..Looks like my early. Bulge on case but mine had a T98 cover. Hopefully you don't have to drive too far to pop the cover and look.
-
My welding table covers a bunch of bases: tool storage, air circulation, power… everything in my shop is on wheels and does multiple...
-
53A1 replied to the thread Welding Table vs. A Table To Weld On.I have two wood workbenches in my 2 car garage. One is 7 feet long and the other is 5 feet both heavy duty built with 4x4 legs. The 5...
-
I’d pull the top off the carb to check the fuel bowl. I wouldn’t be surprised if it all gummy from old dried up gas. If is is less than...
-
I think I would go ahead and change the oil if it will turn over ok. Also I would check the compression on all cylinders, In order to...
-
Yes oil change first. Then turn over with the plugs out using the starter for a few minutes to get he fresh oil everywhere; this will...
-
53A1 replied to the thread F134 Engine Revival Plan.Old engine revival is tricky. Hydraulic lifters are the worst for getting stuck but you don't have to worry about that. Always start by...
-
A SOLUTION OK I know I got a bunch of threads on this spread around the forums. I drove up to Herm's this morning. I had an...
-
53A1 replied to the thread Golden Burro.I have both. For off-roading with tight maneuvering it's almost essential. Try turning around in a steep, tight desert wash with 33s or...
-
After I added a rear lunch box locker to my modified 47, I don’t need to engage the front axle as often. I would rather have a...
-
-
Loading…
-
Loading…