-
-
IMG_1868 by ZachG, on Flickr Cleaned and lubricated a set of old warn hubs to finish the 30 install and took a short ride. The hanging... -
Moving forward on the CJ to Moab list. Would you believe that all of the tie rod ends are shot?… yup, I wasn’t surprised either. Parts...
-
Making headway again. Shock mounts are in. These are a copy of Norcal's design. Simple and strong. Still need to make the final welds on...
-
BDS said the order should be shipping out this week. While I wait, I’ve been focused on the hanging pedals. I thought with a little...
-
I finished my GPS speedo install by removing the cable, removing the bushing, removing the speedometer gear, and installing the proper...
-
After work, I winched the jeep on to the trailer for the ride to the Partsdude shop in the morning. It's good to get it out of the...
-
With both seats in, I can see the clearances I have. This is going to be a major improvement on comfort. And they look good too. I...
-
homersdog reacted to jeepljeff's post in the thread 1952 M38a1 Build: Not For The Purists with
Like.
Well, that was unexpected. Checked my email and saw a pic of my Jeep. It's being featured in this months Kaiser Willys Newsletter and... -
Here are a few pics of the rig fresh out of the "paint booth". Assembling all the rebuilt parts was fun. Lots of satisfaction seeing...
-
I'm really tempted to change the ratio in the rear axle on my pickup. I've read and watched some videos, it doesn't seem that scary to...
-
Didn't have any time to work on the Jeep last night, but I made some progress tonight. Amazingly, the MAPP gas torch can get 1/4" thick...
-
Some good info guys! I'll post some more pics as soon as I can.
-
In a lengthy conversation with mike owner of TA performance about keeping cams alive he recommended STP motor oil treatment in the blue...
-
I'm going to try those tires on the TJ, 285-75R16's. Right at 33" tall. I can't see them wearing any faster than any of the KM's I've...
-
homersdog replied to the thread Some earnest tub questions.In my experience if you can make decent stick welds then flux core mig will be easy for you. I would suggest Unistrut to make weld...
-
-
Loading…
-
Loading…