1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Taking The Temperature On A Dauntless

Discussion in 'Early CJ5 and CJ6 Tech' started by Lee Bennett, Jul 19, 2019.

  1. Jul 19, 2019
    Lee Bennett

    Lee Bennett Banned

    Joined:
    Jan 2, 2019
    Messages:
    291
    Does anyone know where I can install an analog temperature sensor on my Dauntless? PO has installed a offy with only 1 out port which has the idiot light sensor in it. The probe for the analog is about 2 inches long. Is there a port in a head I could hook in to?
     
  2. Jul 19, 2019
    rejeep

    rejeep Well-Known Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Rochester, NY
    Joined:
    Nov 5, 2009
    Messages:
    1,691
    Drill and tap a water outlet /
    Brass T fittings on intake as a splitter
     
  3. Jul 19, 2019
    Lee Bennett

    Lee Bennett Banned

    Joined:
    Jan 2, 2019
    Messages:
    291
    Probably going to have to go with the T fitting method. After all, anywhere you probe will have a different number depending on flow. Some areas have no real flow. Mostly stagnant water. But it is relative and I can at least monitor for changes.
     
  4. Jul 19, 2019
    rejeep

    rejeep Well-Known Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Rochester, NY
    Joined:
    Nov 5, 2009
    Messages:
    1,691
    Better than a splitter would be a splice in a coolant hose with a fitting, and you don’t need a ground since mechanical.
     
    jeepstar likes this.
New Posts