Pto Winch Pillow Bearing

I'm looking for a pillow bearing for my PTO winch. I can run either a 3/4 or 7/8 shaft. Does anyone have a part number for one?
Thanks
Jay

 

What size are your ujoints on the PTO shaft the pillow block will need to match those. My ECj5 had the pillow block bolted to the bellhousing then angled up to the winch.

Here's a verticle 3/4" pillow block, you will have to make a flat bracket to support the block and bolt to your bellhousing or whereever you need support

Huge Selection Of Strong Flange Bearings | Zoro.com

picture of bracket to hold pillow block located near the bottom on this post in the Koenig ad

Koenig "King" Winches

 

There is A flange bearing and there is A pillow block.

Most I have seen where Flange Bearings.



For The 2- Bolt Flange Sealmaster SFT12 , 3/4"

For The 2- Bolt Flange Sealmaster SFT14 , 7/8"

For The Pillow Block Sealmaster NP 12 , 3/4"

For The Pillow Block Sealmaster NP14 , 7/8"

These have set screws in the inner race to lock them to the shaft which is best

for reverse able applications.

 

Thank you. Now if I could find the angle the they are good to!!
Jay

 

If You are asking about misalignment it is + or - 2Degrees .

 

Mine have just had a welded tab to bolt against the bellhouse. Easy enough to fab and or bend as needed.

But the units I've seen look like they could handle 5º to 10º or more of misalignment.

 

I ordered a couple different ones, I will update the post when they get here.
Thanks
Jay