Nothing special here. I'm learning as I go along. The jeep is a 66 and I'm a few years older than her. I've never had much Automotive experience. As I've driven a new truck since I've been able to afford to. I've had this Jeep in my garage for nearly 10years. I just didn't think I was up to the task of making it safe. In the mean time I've stalked a little here and recently posted a few questions. I've collected a lot of new and used parts and now I'm ready to rock. I'm definitely doing the following before I start driving her..... 1 Replace floor, riser, floor supports and patch a few rust holes. Done 2 Power steering Done 3 Dana 30 swap w/ disc brakes Done 4 All new brake lines Done 5 New fuel tank and fuel lines. (under seat plastic)Done - Rear 15 gal fuel tank from 79 CJ 6 New seats Done- Roxor Seats 7 Straighten frame - driver side near pedals seems tweaked Done 8 Paint frame - Frame is mostly rust free (body is off so might as well) Done 9 New wheels (black) and tires (BFG AT) Done 10 New windshield frame and glass Done 11 AA chain clutch linkage Done 12 YJ springs front and rear. Done Going to paint only as needed this time around with rattle cans. Edit Going DYI two stage paint I'll try to keep y'all updated with lots of photos.