1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

11" Drum Dana 30 Hard Lines on Single Reservoir Master

Discussion in 'Builds and Fabricators Forum' started by Mike C, Nov 17, 2015.

  1. Nov 17, 2015
    Mike C

    Mike C Member

    Austin, TX
    Joined:
    Feb 19, 2007
    Messages:
    743
    Not sure if it's me or the forum, but I searched to no avail. After another wheel bearing failure on my Dana 25 (just swapping in old used parts ain't gettin' 'er done!) I'm almost ready to do my Dana 30 swap with 11" drums. I have a set of stainless lines and am planning on bending some new steel lines.

    Any recommendations on routing or pitfalls I should avoid? Should I run through the frame rail or should I put brackets for the lines either above/below the frame?

    I know this has been covered so my apologies if it should have been found easily.
     
New Posts