I PUTT THE AA KIT IN MY TRANSFER CASE LAST YEAR AND ITS BEEN GREAT! ITS QUIET ALL THE TIME. THE MAIN REASON I PUT IT IN WAS BECAUSE I COULD NOT...
I HAVE A 67 CJ5 WITH V-6 MY FUEL LINE COMES OUT THE BOTTOM OF THE TANK. IT ALSO HAS A DRAIN PLUG IN THE BOTTOM. IT WAS THE ORIGINAL TANK UNTIL...
i'm on my second set of cooper discovers i bought the first set in 1987! Just replaced them last month, they had good tread but i was wary of the...
If you need a dash pot just go to any parts store and get a sixties gm dashpot. They were all the same. Jeep used the same suppliers as buick...
Just read this and have a quick question for anyone with info. I have a early 67 cj (single chamber master cylinder. Does the later two chamber...
There is a company that makes new axle housings to upgrade to onepiece axles, But do to my old age i cant remember the name of the company right...
I also had to grind my washer to clear with a t-86, everything is stock, so i bet everyone has to clearance the washer ohale
quick question, did it come with the retainer ring? mine is missing and i have not been able to find another thanks, ohale
Well, as all things happen my gas tank started leaking just as i was getting everything else up to snuff. My question is what is the difference...
I JUST COMPLETED MY T-86 REBUILD AND D-18 REBUILD. I INSTALLED THE A.A. INTERMEDIATE SHAFT UPGRADE AND I ALSO BUILT MY ON CHAIN CLUTCH LINKAGE,...
Well, i did what Nickmil suggested, feeler gauge indicated about 12-15 thous gap. I pulled it apart and I had installed the locking plate on the...
THANKS, THE FEELER GAUGE IS SOMETHING THAT I'LL TRY. I WAS JUST HOPING THAT THIS IS A COMMON ENOUGH PROBLEM THAT SOME ONE COULD SAVE ME SOME...
I agree I just did the conversion on mine,and after putting it together things are pretty close. Of course anything can be done with enough...
Yes,I put put the bearing adapter into the trans as i felt this was correct. I then put on gasket coated with copper coat sealer. when i started...
When you put your transfer case onto your transmission Does the bearing adapter go in after the transfer case is bolted up.to the transmission?...
Just wandering if anyone has used any of the omix-ada speedometer driven gears to calibrate their spedometer. i just found the part numbers and...
Mc Ruff, I too am in need ofshims for caster adjustment. 2* or 3* would be what i'm looking for. If you have /or can make them please let me know...
You're right it is a d-18 transfer case. Sometimes my brain and fingers do not communicate properly
Has anyone used the Advance Adapters T-18 intermediate shaft conversion? any thoughts on same? thanks
May have i have just seen duel m/c referenced for the 67. That's why i/m asking
Separate names with a comma.