The 3B has a pretty good running fhead, but we are going to see how much better it runs, if at all, with fuel injection. In reality it probably...
I Finally found a good venting windshield for the 3B but with broken glass, I’m having glass cut to fit now. The gasket between the fixed frame in...
After searching for a long time for a good 3B fold out windshield, the search has ended. I didn’t only find a good one, I found a mint one, pretty...
i started building the 3B with no real plan, as its evolved it has taken on a old service station theme as I’ve added the OBA, welder etc. Which...
just some pics Incase someone is looking to do it on a fhead. The extra 3B space is a huge plus! Fabbed up some brackets off the exhaust...
New alternator and welder mounted in the 3B, just need to wire it up. Finally got the correct pulley for the alternator so I can use the...
I wanted to do it as simple as possible using a filter that most Oreillys have on the shelf. the male end of the fitting fits the K&N with no...
Im looking for a good high amp solenoid i can use to control the old bellieview, not a fan of the knife switch. i want to run power through...
i have been messing with this fhead for a while now, it runs ok i guess. But still seems a little rough, and i cant get a real good reading...
On the 3B i always planned on the build theme as an "old service station" willys, so i thought i would be cool to make it functional on the trail....
my plan on the 3B is to eventually go to a 4speed, granny low behind the fhead. Was planning on t98 but open to any thought. I was at a swap...
The 3B I just picked up is running now, just not too good. I think most of the problem is the carb, it has a solex on it. Everything I have...
we all know there are lots of opinions on fender well mounted rollbars, I for one, think they do provide a margin of safety if mounted properly...
Since getting a trailer at the beginning of the year, jeep hunting has become my new hobby, 4 different willys have all shown up in the past 6...
so my new project is a 59 3B, i picked up 2 rebuilt axles for it, when i tighten the pinion the dust cover hits the seal at the arrow. [IMG]...
I had picked up a cool 2A, that I was going to rebuild, but the frame was way beyond savable. I picked up a mint 3B frame that I was going to...
Just about done rebuilding a d30 for the willys, It prev had big disk brakes swapped on using 6 hole brackets. I discovered that both sides the...
I found my old, but hardly used Cagle. I was thinking about putting it on the 4.3/ quadrajet. Anyone know anything about these, any concern...
is the standard still 1-2 deg down at the pinion for the short wheelbase jeeps, i always used that number with no problems, but that was was for...
I picked up this tank as I thought it was the one I needed,I believe its from the later 70's cj5. It's about 16.5" deep. Looking at the Willys...
Separate names with a comma.