I check the capacitance of condensers when installing new or having a mystery problem. Most meters have a function to check that size. If needed,...
There’s a thread with dimensions on the bracket, let me find it. And yes the pedal is absurdly uncomfortable without it and IMOP fine with it...
The lack of that bracket does indeed make the pedal sit higher. Which made my Jeep uncomfortable to drive. Homersdog made a drawing where you...
Not mine...
Google says you must disconnect msd and go back to original to check dwell The Internet said it so 50/50
Innova digital worked as expected.
I don’t have the fsm so it might be called out, but is there a different end play clearance if you’re using used bearings? I’m going to remove...
Typically, if it was a fuel stoppage, it would gain rpm and start hunting. That would be as the bowl is being emptied. If it pretty immediately...
If misbehaving on a slope, have you confirmed the float level and function?
I can not vouch for my Jeep as being “original” nearly as confidently as fireball, but I believe my frame and running gear is factory v6 of the...
Thanks fellas, this was my assumption but wanted to confirm. I might remote the vent through top of cap to help me sleep at night. I did suck out...
Just looking for a sanity check. I replaced the single mc on the 65. The old one had the cap seized on. Upon removal rust colored fluid dribbled...
The external resistor is not the r terminal, just to be clear. I am unaware whether or not the petronix uses a new coil or existing. The r...
Beach66bum, which top uses those brackets pictured? My windshield has those and was going to remove them and weld the holes. Or do they serve some...
Will the transmission crossmember that’s available from Kaiser willys work with a t14? It states t90. Also, for those that know, is the adapter...
And it seems that all of the removable pieces were black. Thanks again
Thanks, somehow in the plethora of the Internet I forgot they had a really good gallery
Hi all, was looking at several near original jeeps and am unclear about if only the tower hump was painted black or all the removable pieces....
I’m used to starting old vehicles, but picked up a little extra wisdom on here recently. Before pumping the gas pedal, crank for a few seconds....
If you have the 6 screw sender, place a sta-kon under a screw and run a wire to the body.
Separate names with a comma.