So I have a noticeable clicking noise that increases as RPM increases on the engine. I am thinking it may be a bad lifter. I am thinking of...
Does anyone know where I can buy the bracket that holds the manual choke cable for a Rochester 2G carb? I can’t seem to find them anywhere online.
So I finally got my 1969 CJ5 running but I am in need of some help with my carb and keeping the Jeep at idle. If I keep the choke closed...
I have a set of Edelbrock Chrome Valve Covers that are new in box. They are model 4486 which is for a 3.8L and 4.1L Buick V6. Asking $65.00 or...
Omix makes a kit for a 78-86 Jeep CJ-5, CJ-7 & CJ-8 that is a 10"x2" Drum Brake Master Service Kit (New Drums, Springs, Clips, etc.). Can anyone...
Maybe I am going crazy but I am in the process of replacing some heavily rusted/corroded brake lines with stainless lines from Inline Tube (highly...
I am looking for a good and affordable mechanic in Orange County, California to help me with finishing some basic things on my Jeep that I just...
So I am at a loss on my 1969 CJ-5 and I am in need of help. I am wiring the Jeep with a painless kit and for the life of me I just don’t quite...
So I have a keyed ignition with an Ignition, Starter, Accessory and Battery connection on the back. I am re-wiring with a painless kit and there...
So I purchased new windshield rubber to go around the original glass as the old stuff was hard as a rock and I needed to get it off in order to...
So I am having to switch to an electric fan due to some clearance issues with my new radiator. If I am mounting the fan on the inside of the...
So I had to make due with what I had since the actual radiator for my Jeep is out of stock for the foreseeable future. My question is, how much...
So I live in Southern California and I am in the process of a 1969 CJ5 rebuild and was considering with all of the other work I am doing to it, I...
So I ordered these push rods from Rock Auto for my 225 V6 Rebuild:...
I have a Dauntless V6 and after realizing some issues with the stock headers from the PO I decided to buy a new aftermarket set of Hedman’s. can...
I am thinking of running AN Fuel Lines and fittings for my 1969 CJ5 rebuild. Has anyone done this on here or are the rigid steel lines better? If...
I am looking at replacing all of the bolts on my 225 V6 with stainless bolts and washers and I was wondering if they are the same as the 231 Buick...
So my '69 CJ5 has a ton of sand and dirt build up over the entire engine (my guess is from sitting in the Arizona desert). I am looking for help...
Has anyone replaced their 2G Carb with the following: Rochester 2G - Summit Racing I have a 1969 CJ5 with the 225 Buick Odd-Fire Engine. What...
Hey Everyone, So I recently purchased a 1969 Jeep CJ5 and wanted everyone to be able to follow along in my rebuild process. Below are some...
Separate names with a comma.