T15 bolt in and replace my t14 behind dauntless 71?
Need 71 cj5 tailgate. Thanks
Correction my 69 has remnants(rubber gone) on both sides of frame like my 71 both v6. My guess AMC deleted that ARM for some reason. Look like...
The 71 does have bumpstop on frame Thought arm might keep axle from twisting? So 69 and earlier have bumpstop on extended arm?
Cj5 69 v6. Planned swap complete front end with 71 both dana 27 v6 but 69 has 6 inch arm on passenger side with rubber stubber.. also knuckle...
Rebuilding 70 cj5. Spare Dana 27 with 2 hole knuckle . To replace 69 dana 27 1 hole. What advantage does 2 hole have over 1 hole knuckles.
Thanks Petel I just silicone it.
Cj5. Not cut...
Replacing windshield gasket that seals cowl and defrost vents. Found small 90 degree rubber seal under thick rubber seal I'm replacing is this...
My 71 cable operated used luk 04021 with different throwout. Raised diaphragm not flat fingers. Rockauto shows 01029 flat type pressure plate...
Took off master and found light corrosion on bottom of bore. Cleaned up with 600 grit paper and ready go back together. Now to get slop out of pedals.
Thought about shimming master with washers or cut rod. Yes could be jamming but does it with cold engine.
Happened several times over last couple months. New hoses and yes outside and cold using synthetic fluid.
69 CJ5 V6 front brakes locking up. Loosen brake line good to go. Master and wheel cylinders 2 yrs old. Jeep Manuel says need adjust freep play...
Yep on wall still in package didn't like pedal end so running crown 2 yrs. They agreed do free shipping.
Thanks for advice. Decided convert to cable like my 71. My new inline tube cable popped swagged end after 5 mintues.... PO 3:1 arm ratio lowered...
I replaced clutch in 69 225 3 SPDR and now trying to hook clutch linkage up. Think po had wrong pressure plate because both rods have been...
LUk 04021 raised finger diaphram works on 70 & 71 cable operated clutch. Rock auto lists flat diaphram which won't release clutch. Ash me how I know.
Well now plan b or c... I mismeasured intermediate gear width. Mine is around 2.750 pulled another gear from spare transfer and it is 2.775. Gear...
Separate names with a comma.