Is there a better Housing Cap for the Tremec T176 than the Crown part # J8134667? I would rather something machined or forged, the stamped steel...
Question, does the Lower Steering Shaft (Part # 999-714) for a 1973 C104 Jeep Commando with Power Steering supposed to have a slide joint in it?...
Was troubleshooting the aftermarket tachometer which stopped reading and discovered that if the signal wire from the HEI distributor to the Tach...
Any of you install an engine block heater in your commando, specifically the :amc: AMC 304? I will admit, I live in Houston, and it doesn't get...
Anybody with a Parts Commando that has the original seat supports they feel like selling? A PO installed bucket seats in my 73, looking to...
To you guys with lifted Jeeps, I'm still working the 73 Commando. This is the one with a [IMG] 304 that has a Holley 4160 mounted on the 2-barrel...
So, still picking away at the 73 Bullnose. Been chasing a ghost for the past month, pulled the carburetor off twice now. An earlier owner...
I'm working on rebuilding the E-Brakes on a 1973 Jeep Commando C104. This particular commando does NOT have the stock driveline, so I'm hoping...
So, earlier I introduced my 73 Bullnose Commando in the VIN forum... Spent the last few days poking around and investigating, have determined the...
Separate names with a comma.