I was afraid I messed something up. Thank you for pointing this out. My first time. Knew something was wrong.
Can anyone tell what is wrong? Clutch not engaging. See the position of the cable adjustment relative to the yoke. Adjusted enough? Other...
Thanks for the advice. I disconnected at the clevis pin, added a jam nut and reattached. I then tightened another 1/2 inch. Still can’t shift...
Thanks I’ll do that. Turning the yoke will shorten the overall length of the cable and yoke. How do I reattach the yoke at the clevis? Do I need...
Got engine running after head gasket replacement. Noticed that my new clutch cable needs to be adjusted in. When I turn the cable it springs...
Think I’ll rule out the head off the old engine. Circled where my leak is and apparently that recession is part of the head (although not sure...
Thank you both for your input. I’ll pull both this weekend and see which is best.
Continue to underestimate the Gremlins on my first ever restoration. bought a used F134 engine last year. Was told it was running fine but taken...
Thanks for the advice.
Are the Dana 25 and 27 components interchangeable? I’m finding Dana 25 parts but not Dana 27
Finishing up my 1955 CJ5 rebuild. Front differential has broken spider gear teeth. My front axle is stamped 27 so assume it’s Dana 27 not 25...
I can’t find anything in the engine that looks to have broken. I’ll button it back up and let you all know if I can get it started. Thank you...
Thanks
The fuel pump on the engine has the actuated arm. This one doesn’t look like the old pump or the new one.
Sorry, guys. I said non-metallic but meant non-magnetic. It’s metal. Off a Hurricane 4-134 for my 55 CJ5
Took off oil pan to install new gasket on timing cover. Found this in my oil pan. Engine bought used so I’ve never had it running. Don’t want...
I have seen on here that the measurement for 1955-1975 windshield is 15.5" x 59" with the 76-83 glass is 15.5' x 55". I just bought a frame for...
I purchased an engine from a guy who restored an MB jeep to original. Someone before him had installed an F134 engine and he pulled to install an...
Hey, guys. So I’ve taken transmission apart (again). Bought rebuild kit for T90 and a 2nd gear due to wear. I think I’ve figured out my problem...
Thanks, everyone. When I held the output shaft, it didn’t spin. Definitely some friction there allowing it to turn. I’m out of town but will...
Separate names with a comma.