[ATTACH] This is the Jeep needing to be trailered. Thanks
I have a 1957 CJ5 and need to trailer it 250 miles. It has no top. What is the best way to trailer to ensure the hood stays latched. And...
Thanks. I was thinking of that trimming the metal frame. But the gasket outside pushes on the “Inlay of the MD Juan” frame. So trimming the...
Because the gasket can’t be pushed down smooth. It is curled up and and the glass does not fit smooth at one end. One end is smooth. The other...
I bought the windshield from a good high quality online vendor. The windshield frame is an MD Juan. My original needs lots of work. I thought...
I have a 1957 CJ 5. I bought a replacement windshield. I got the windshield in the gasket in a new replacement windshield frame. The issue is...
I am not sure what model this is, but this was the condition of wires. [ATTACH]
Thank you. Turns out the wires outside the steering column in the rubber cover were in very very bad shape. I had to solder the wires back to...
Makes sense. I probably burned a wire in the area where the brake switch wire arc on frame. So it is sending voltage up the ground is my guess...
It is a 1957.
Thanks. I added ground wires. And it is still happening. Seems like the right blinker power must be sending power down the brake wire on the...
My CJ5 blinkers were fine. This is after a complete rewire. I had a small leak with brake fluid at brake switch near master cylinder. I had to...
I put Rugged Ridge seats in my CJ5. These still seem high despite my efforts to make them as low as possible. Are the bestop brand low back seat...
Nothing wrong with the distributor on a CJ5 F head and runs great, but one of the spring clamps broke. I have look many places but I can’t find...
It’s it ok to remove the heater hose? My heat exchanger was disconnected but a hose loops from the right top around the block. So I would remove...
Yes it is a F134. Does anyone know the tread size for that port? Thanks
What is the best place to put the temp gauge sensor on a 1957 CJ5 engine? Thanks
I have to change the head gasket on my engine in 1957 CJ5. Did you switch to studs? And you put sealant around the new studs and that solved...
They were wired backwards. Thank for the help.
Ok. Thanks. I will switch the wires on both sides.
Separate names with a comma.