found them on market place for $80 bucks. They had a lot of scale on them but cleaned up nicely. There is a another set around here for sale but...
I'm getting really close to having a fun summertime ride. Scored some new tires and rims to help even out the taller gears. 33x10.5r15s. Brakes...
Ended up having to swap my master because mine was bad. Used this one from napa because it had a small boar.82(it was only $26.79 on sale) and now...
I'm finally back on all 4 wheels and the E E Brake works terrific. I still need to get a good bleed to have the brakes work better but I drove it...
I just wired mine up and used resettable breakers it doesn’t pull enough amps to trip them so I think if I were to do it again I would just use a...
Here is what I got Brackets Trackick Disc Brake Conversion Bracket, One Pair Calipers I ordered off ebay $50 a piece Passenger Right Caliper Rear...
I'm doing his brakes on the front too. I should be able to button that up this weekend I am rebuilding the axle then next week will be plumbing...
I just installed mine last night and tested it it with a dpdt switch it was pretty exciting to see the caliper work. For final wiring I am going...
I have had nothing but good luck with trac lok. I had one in a tj stock that hooked up awesome. I had a lunch box locker in the front and it...
Thanks for the input guys I'll get a pick of where the red hose goes too. It hasn't been leaking so i haven't worried too much.
Thank you that’s what I figured I’ll get a proper plug this week and stop that leak.
The previous owner did a heater delete and I keep getting coolant pooling up here. Does this need to be a weep valve or can I just put a brass cap...
This isn't the good pattern but I was done! by the time I finished and didn't take a picture. For disc brakes I went with Brennans Electronic E...
I'm in the middle of exactly this. Had a hell of a time getting a good pattern with the used gear. [IMG] [IMG]
If you want those give a really low ball offer. With out knowing the gearings and keeping in mind that they probably need new seals, brake parts,...
I have a good pair of axles and hubs to sell if you end up cutting let me know. I decided to go to a 1 piece axle shaft dana44 out of a 72 CJ5 so...
Found a New Old Stock Trak Loc for the 30 spline Dana 44. So I have decided to go that direction. That axles is rusted the most so it will take...
I was trying to decide what to do about the ebrake as well and decided to go this route Electric Emergency Brake ( EEBrake ) Rear Bracket Kit,...
Really cool build. I'm in Mass too. Maybe we can get on the trail in the spring.
Is there any problem with the cylinder and manual steering box being different speeds. I have done hydro assist on power steering before and it...
Separate names with a comma.