Awesome job.
Could have pulled a piece of junk into the bypass in the master out of one of the hard lines, my brother had a similar issue with his jeep.
That bottom one may be a Jackman, they made several different centers.
They don't look that bad I would recover them, new seats are pretty hard foam and you sit on the seat rather than in the seat, if I could find...
I have run H4 LEDs in my FJ cruiser for the last 4 years, and not had any issues with them lasting, and they are the same size as a halogen bulb,...
Those look to be correct, what do the mounting brackets look like.
I have gone to LEDs in all of my rigs, I don't think I could go back to halogen lights so dim compared to LED. :bananatool: Although I do need...
Well I didn't get to do much with my Jeep this weekend but I got to hang out with a few older ones, and drove my brothers 44 a bit....
The plate is for the 24v regulator.
I will bring my jeep by and you can do it next. (y)
Those look pretty close to what is on my 58, looks great.
Yeah, your clamp is not on correctly it should cover the bottom of the air horn lip and the lip of the Carb.
If your going to an automotive shop, my dad had this wheel for his grinder that he called and eraser wheel that will take all the sticky off and...
It seems like I also need to put a cut off switch on mine as well, if I let it sit it will drain the battery, mine is either the wiper motor, horn...
I saw that they are on the site, I will be ordering soon. Thanks
Took two speedometers and made a good one. IMG_20210717_153230015_compress51 by Puddle Jumper posted Jul 17, 2021 at 6:58...
Thanks to Garage Gnome for the speedometers, I was able to piece together a pretty nice one out of the two. IMG_20210717_153232607_compress0 by...
Separate names with a comma.