My starter went out in the 66. It’s got the factory dauntless. How do I know if it’s 153 teeth or 160 without counting it hahaha
Need a new starter on my 66’ is the tooth count the same? Summits got them in stock. Gonna go pick it up before they close.
[ATTACH]well after 3 weeks and 600 miles, it was time to go drop off the Jeep and pickup my car that’s been sitting in a dirt lot behind a shop...
Was a good time forsure. Been daily driving it for just over 3 weeks and put 600 miles on it.
Go for it! I’m 5’6 and my heads just to the front of the toolbox lid.
Yeah I little bit but semis on the California side is 55mph I think so they were doing the same speeds 60-65. I even made a couple passes along...
FIRST ROAD/ CAMP TRIP. First trip out of town heading up to Lake Tahoe, Then staying the night in truckee CA. Grabbed some fuel, checked the oil,...
I’ll be in truckee Sunday! In the Jeep. Going up Saturday to camp with some buddies. Gonna head up threw incline when I get off work. Then dodge...
Just got my tires balanced, after driving it for a few weeks. Damn thing feels like a Cadillac now compared to what it used to feel like. Before...
finally got the Jeep registered. Which means I’ve been daily driving it. It’s been 90’+ here so I went with some heat and sound stuff for the...
measured out some patch panels. Nothing crazy. But I just can’t ignore it. [ATTACH] [ATTACH] Right side was a bit worse. But not too bad....
[ATTACH] [ATTACH] [ATTACH] started fresh and made a new plate. used 16 gauge cause it was all I had. I’ll worry about a shift boot setup later.
[ATTACH] [ATTACH] was able to get the old stickers off the bumper too. Little wins. Trying to do something everyday on it.
[ATTACH] rough cut the commando bumper this weekend. Once I have the brackets bolted to the back of the bumper, I’ll cut and round the edges....
[ATTACH] anyone know where I can get a replacement fan dash knob? Or if someone can show me an example of theirs?
If you could measure the length of the bracket as if the bracket was flat, that would be great. And then depth from the crossmember to the...
[ATTACH] new hose for the heater box [ATTACH] Slowly getting the rubbers together and sealing up the floor
[ATTACH] [ATTACH] was able to pick up a commando rear bumper. It’s roughly 6 inches longer the front bumper I have. So I’m going to cut off 3...
Also if anyone is looking for a clean looking heater core bypass hose. [ATTACH] [ATTACH] https://www.summitracing.com/parts/dac-80412 I used this...
[ATTACH] [ATTACH] Out with the old. And in with the new. [ATTACH] [ATTACH] only so called issue I had was one bolt was too far off to bolt in...
Separate names with a comma.