On the Kaiser Willy site 646509 looks correct. I know the bracket that fastens to the floor is correct. And the pedal comes off it at an angle,...
Good pics from Jeepster. Mine came with an L shaped metal bracket that is held on by the last bolt that holds the exhaust manifold on. I "assume"...
If your talking about the throttle return spring...I first installed one from the coil bracket to the carb but found at full throttle it over...
Looks good! I might recommend beveling the inside of the tube on each end. They can be pretty sharp after running thru the threading machine.
I have a vacuum advance IAT 4024 distributor on an F134 motor in a 1958 model. Pertronix says they don't offer an ignitor for this distributor....
That's it! It is held by the bolt, that is just above the fuel pump, that holds the timing cover to the engine. The cable goes from the...
Nothing between the rod and underside of the floor. And I am in complete agreement about metal on metal, but this is the way they designed it. I...
Check your thickness. As built the pedal rod is right against the underside of the sheet metal floor. If this moves it down from the floor I don't...
The pieces I used have very little bend to them. You can get 1/8" plywood, 2.7 mm, at any big box store. I wanted plywood as it is more resistant...
If you have even a little skill you can repair broken fender flairs using fiberglass. Out of 2 sets of flairs I was able to get only one of the...
[ATTACH] [ATTACH] Cabinet shop also did the arm rests for me. I got the black plastic push pins off of ebay. $7 for 50 delivered.
I tried to make a headliner using a piece of highly bendable plywood I got at a cabinet shop but just could not get it to fit right so went this...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] Thought I'd show how I made door panels. I use regular copy paper to create a template. Way easier than trying...
It was the pilot bushing, dang. All back together and working. Initially the clutch was still dragging a bit, I attribute that to a new disc and...
Merry Christmas to all...I could not sit thinking about this and Festivities don't start till 1 pm so I went out and pulled this apart, took less...
The gas pedal and bracket are available from about everybody. The bent accel rod not. Midwest Willys has a lot of used parts and should have this....
I had my early FC150 red recore'd recently. $412 including tax. There are only a few companies nationwide that still make the copper cores your...
This is my drivers floor when it arrived. I used fiberglass to repair all the rust thru spots on the vehicle. easy to work with and won't...
Here is pic of rod assembly on underside of floor. 4 Bolts thru straps also go thru reinforcing plate on top of floor. Two staggered bolts hold...
The accelerator rod goes thru the floor, makes a 90 turn then another 90 turn up the side of the footwell. The accel wire is fastened to it and...
Separate names with a comma.